> ## Documentation Index
> Fetch the complete documentation index at: https://docs.plato.ae/llms.txt
> Use this file to discover all available pages before exploring further.

# Epson TM-m30II

> Configure an Epson TM-m30II Ethernet or Wi-Fi printer for Plato.

Use this page for TM-m30II printers with Ethernet or Wi-Fi network support.

## Supported Connections

| Connection   | Plato setting |
| ------------ | ------------- |
| Ethernet/LAN | `Network`     |
| Wi-Fi        | `Network`     |

## Configure From A PC

Use TM-m30II Utility, EpsonNet Config, browser config where available, or the printed setup flow.

1. Connect the printer to the router or switch by Ethernet, or directly to the PC for recovery.
2. Print a status sheet and note the IP address.
3. Put the PC on the same network or subnet as the printer.
4. Open the Epson utility or `http://PRINTER_IP` if web config is available.
5. Configure IP, subnet mask, gateway, and Wi-Fi details.
6. Save settings to the printer.
7. Restart the printer if required.
8. Print a new status sheet and confirm the final IP.

## Print Self-Test

1. Load paper and close the cover.
2. Turn the printer off.
3. Hold `Feed`.
4. Turn the printer on while holding `Feed`.
5. Release `Feed` when printing starts.
6. Press `Feed` briefly to continue the self-test if prompted.

## Print Status Sheet

1. Turn the printer on.
2. Confirm paper is loaded and the cover is closed.
3. Remove the bottom cover if needed.
4. Hold the status sheet button for at least three seconds.
5. Read the printed IP address, MAC address, and network status.

You can also open the roll paper cover, hold `Feed` for at least one second, then close the cover to print a status sheet.

## Restore Defaults From Feed Button Menu

Use this only when support asks or settings are unrecoverable.

1. Run the self-test.
2. Hold `Feed` for at least one second to enter mode selection.
3. Press `Feed` briefly four times.
4. Hold `Feed` for at least one second to enter restore default values.
5. Press `Feed` briefly once.
6. Hold `Feed` for at least one second until the restore completion message prints.

## Initialize Network Interface

1. Run the self-test.
2. Hold `Feed` for at least one second to enter mode selection.
3. Press `Feed` briefly five times.
4. Hold `Feed` for at least one second to enter interface setup.
5. Follow the printed menu.
6. Select Wi-Fi/Ethernet setup or Bluetooth setup, then choose initialize.

## Configure In Plato

1. Add a `Printer` device.
2. Set `Connection Config` to `Network`.
3. Enter the printed IP address.
4. Enter the printed port, usually `9100`.
5. Configure the printer template.
6. Connect the printer to the correct POS.

## Manufacturer Reference

* [TM-m30II Technical Reference Guide](https://files.support.epson.com/pdf/pos/bulk/tm-m30ii_trg_en_reva.pdf)